Toshiba RAV-SM564UT-E Service Manual page 185

Toshiba SDI / DI tuotteiden jälleenmyyjä pääkaupunkiseudulla on Jäähdytinpalvelu RefGroup Oy.
No. Part name
1. Detachment
Drain cap
6
1) Carry out work of item 1 of
2) Loosen screws (3 positions) fixing the drain
NOTE :
The drain cap is hung down because a strap
is attached to it (outside).
3) Loosen the cap by turn the drain cap
NOTE :
Be sure to catch drain water using a bucket,
etc. when loosening the drain cap.
The insulating materials are adhered to the
drain cap (outside) and opening part of the
drain pan; be careful that they are not come off.
If they are come off, stick them as before
using double-faces tape, etc.
4) Turn the drain cap once again to OPEN
2. Attachment
1) Insert the drain cap (inside), turn it to
NOTE :
When attaching the drain cap (inside),
remove dirt attached to the packing.
And tighten in it noting so that the cap is not
slantingly set.
If attaching the drain cap as dust or dirt is
attached or the cap is set slantingly, water
leakage is caused.
2) Turn the drain cap (outside) to → direction
3) Following to work of item 2 of
Procedure
cap (outside) and then turn the drain cap to
the arrow mark direction to remove it.
(inside) for approx. 1 turn to OPEN →
direction and then drain the drain water
accumulated in the drain pan.
→ direction to remove it.
CLOSE → direction until the position
where "Clashed sound" is heard and it
cannot be turned more over
(Position where mark of the drain pan
matches with mark of the drain cap
(inside)) and then fix it.
and then attach it using the fixing screw as
original.
the suction grille as before.
www.ilmalämpöpumput.com
1 .
CLOSE CLOSE CLOSE
OPEN OPEN OPEN
CLOSE CLOSE CLOSE
OPEN OPEN OPEN
Drain cap Drain cap Dr ain cap
1 , mount
– 185 –
Remarks
Drain cap (outside)
Strap Drain cap fixing screws
Drain cap (inside)
mark mark mar Drain pan Drain pan Dr ain pan mark mark mar