Toshiba RAV-SM564UT-E Service Manual page 191

Toshiba SDI / DI tuotteiden jälleenmyyjä pääkaupunkiseudulla on Jäähdytinpalvelu RefGroup Oy.
14-1-2. Slim Duct Type
RAV-SM404SDT-E, RAV-SM454SDT-E, RAV-SM564SDT-E
No. Part name
Be sure to put on gloves at working; other-
wise an injury may be caused by parts, etc.
• Before replacement of the parts, be sure to stop
operation of the air conditioner and turn off
switch of the breaker.
1. Detachment
Air Filter
1
1) Push knobs (3 positions) of the air filter
2. Attachment
1) Insert the air filter surely into the hooking
NOTE)
In case of sucking system from bottom side,
installation direction is determined. Install the
air filter so that hooks are aligned at discharge
side.
1. Detachment
Plate inlet-A
2
Plate inlet-B
1) Take off fixing screws while holding the plate
inlet-A with hands to remove it.
(Sucking system from rear side: Ø4 × 10, 8 pcs)
(Sucking system from bottom side:
Ø4 × 10, 11 pcs)
2) Take off fixing screws while holding the plate
inlet-B with hands to remove it.
(Ø4 × 10, 6 pcs)
NOTE)
Be careful that sheeting metal does not fall
when removing the plate inlet.
2. Attachment
1) Using the screws taken off in procedure 1.
Procedure
XREQUIREMENTX
hooks toward the arrow direction to remove
the air filter.
grooves (4 positions) at the opposite side of
the hooks, and then fix it to the original
position.
2) of 2 , attach the plate inlets in order of B
→ A while holding them not to fall down.
www.ilmalämpöpumput.com
[In case of sucking system from rear side]
[In case of sucking system from bottom side]
Air filter Air filter Air filter
[In case of sucking system from rear side]
Plate inlet-A: 8 screws Plate inlet-A: 8 screws Plate inlet-A: 8 screws
[In case of sucking system from bottom side]
Plate inlet-B: 6 screws Plate inlet-B: 6 screws Plate inlet-B: 6 screws
– 191 –
Remarks
Air filter Air filter Air filter
Hook Hook Hook
Push Push Push
Hook Hook Hook
Plate inlet-B: 6 screws Plate inlet-B: 6 screws Plate inlet-B: 6 screws
Plate inlet-A: 11 screws Plate inlet-A: 11 screws Plate inlet-A: 11 screws
Push Push Push