Manufacturer's Warranty - Tools; Fcc Statement (Applicable In Us) / Ic Statement (Applicable In Canada) - Hilti PRE 3 Operating Instructions Manual

10. Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
en
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Hilti consumables, components and spare parts may
be used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
ment as a result of normal wear and tear are not
covered by this warranty.
11. FCC statement (applicable in US) / IC statement (applicable in
Canada)
CAUTION
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful in-
terference in a residential installation. This equipment
generates, uses and may radiate radio frequency
energy. Accordingly, if not installed and used in ac-
cordance with the instructions, it may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
12
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or
inability to use the tool for any purpose. Implied
warranties of merchantability or fitness for a par-
ticular purpose are specifically excluded.
For repair or replacement, send the tool or related
parts immediately upon discovery of the defect to
the address of the local Hilti marketing organization
provided.
This constitutes Hilti's entire obligation with regard
to warranty and supersedes all prior or contempor-
aneous comments and oral or written agreements
concerning warranties.
equipment off and on, the user is encouraged to try
to correct the interference by taking the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Consult your dealer or an experienced TV/radio tech-
nician for assistance.
NOTE
Changes or modifications not expressly approved
by Hilti could limit the user's right to operate the
equipment.