Before Returning For Repairs - DieHard 28.71219 Operator's Manual

PROBLEM
CHECK BATTERY
(red) LED is lit.
(continued)
CHECK BATTERY
(red) LED is blinking.
Battery clips do not
spark when touched
together.
16.

BEfORE RETURNINg fOR REPAIRS

16.1 When a charging problem arises, make certain that the battery
is capable of accepting a normal charge. Double check all
connections, the AC outlet for a full 120 volts, the charger clips
for correct polarity and the quality of the connections from the
cables to the clips and from the clips to the battery system. The
clips must be clean.
16.2 When an UNKNOWN OPERATING PROBLEM arises, please
read the complete manual and call the customer service number
for information that will usually eliminate the need for return.
If the above solutions do not eliminate the problem or
for information about troubleshooting or replacement parts, call toll-free
7:00 am to 5:00 pm Central Time Monday through Friday
POSSIBLE CAUSE
Battery is not
properly connected to
the charger.
Charger is in abort
mode.
The charger is
equipped with an
auto-start feature.
It will not supply
current to the battery
clips until a battery is
properly connected.
Meaning, the clips
will not spark if
touched together.
from anywhere in the U.S.A.
1-800-732-7764
17
REASON/
SOLUTION
Make sure the
connections from the
battery connector
cable to the battery
and to the charger are
tight.
See "Aborted Charge"
in the OPERATING
INSTRUCTIONS
Section.
No problem, this is a
normal condition.