Before Returning For Repairs - DieHard DH6L Operator's Manual

PROBLEM
Green LED is flashing
and the display shows
CHARGE ABORTED-
BAD BATTERY.
The display shows
CONNECT CLAMPS.

16. BEFORE RETURNING FOR REPAIRS

• When a charging problem arises, make certain that the battery is capable of
accepting a normal charge. Double check all connections, the AC outlet for
a full 120 volts, the charger clamps for correct polarity and the quality of the
connections from the cables to the clamps and from the clamps to the battery
system. The clamps must be clean.
• When an UNKNOWN OPERATING PROBLEM arises, please read the
complete manual and call the customer service number for information.
This will usually eliminate the need for return.
If the above solutions do not eliminate the problem,
or for information about troubleshooting or replacement parts,
POSSIBLE CAUSE
The battery is sulfated.
The battery is too large for the
charger.
The battery voltage is still below
10V after 2 hours of charging.
The clamps are not making a good
connection.
The fuse is bad.
call toll-free from anywhere in the U.S.A.
1-800-732-7764
Reset the charger by briefly
unplugging it.
You need a charger with a higher
amp rate.
Have the battery checked.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the
ring connector.
• 14 •
SOLUTION