Power Mode - Worx WG782 User Manual

3) Slide the mulching insert into the discharge
opening until it is firmly in contact with the
deck.
4) Release safety flap and ensure it is properly
closed.
3. rEmoViNG mUlCh PlUG(15) (See G)
Remove the mulch plug when you desire to
either collect grass or discharge grass from the
rear of the mower.
1) Shut the mower off, wait until the blade
stops and remove the safety key (6).
2) Raise the safety flap and hold it in the up
position.
3) Grasp the handle on the mulch plug (14)
then lift upward and pull it out.
4) Release safety guard and ensure it is
properly closed.
4. iNTElliCUT CUTTiNG modE
SElECTioN (See h)
QUiET modE
Select QUIET mode (20) when mowing in
16 16
everyday conditions, removing approximately
1 inch of grass at a time.

PowEr modE

Set the dial to POWER mode (20) when cutting
dense or overgrown grass.
5. baTTEry STaTUS lEd'S (See i)
NoTE: The Status lEd's will indicate the
battery condition when the button on the
battery is pressed.
The LED's displays the battery condition as
follows:
Press the button "POWERTEST" , the power
level light(s) will illuminate.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is is very low and should be
recharged .
Before using your new mower for the first
time, it is recommended that the unit be
24V 14" Cordless lawn mower
) are illuminated, the
) is illuminated,
charged overnight to ensure that the battery is
fully charged.
imPorTaNT
when only one light is illuminated,
your battery is overly discharged, even
though the mower may still be capable
of cutting grass. Continuing to operate
your lawnmower with the battery in this
discharged condition may reduce the life
and performance of your battery.
6. adJUSTiNG ThE CUTTiNG hEiGhT
(See J)
warNiNG! Before adjusting the mower
height, wait for the mower to completely
stop. Mower blades continue to rotate after
the machine is switched off and a rotating
blade can cause injury. Wait until all machine
components have completely stopped before
touching them.
• The mower was shipped at the lowest cut
height setting.
• Before your first use of the mower make
sure the cut height is adjusted.
• The lawnmower can be set to 3 cut heights
(2" , 2.75" , 3.5")
• Adjust one wheel at a time.
• Remove the battery
• Turn mower onto its left side (Fig J)
1) Grip the wheel and pull or push it forward
(1).
2) Make sure to pull it forward far enough that
is able to be move up and/or down in the
wheel bracket (2).
3) With the wheel in its most forward position
slide it up or down into the new position.
4) Repeat the above steps to all four wheels.
7. GraSS baG FilliNG iNdiCaTor (See k)
To alert you that the grass bag is full, the
mower provides an grass bag level indicator
on the top of bag
Empty status: flap float (a)
Fully status: flap fall down (b)
EN