Battery Care - Worx WG782 User Manual

charge a fully discharged battery)
6. After the battery is fully charged the green
light will turn on and charge it to on for 15
seconds to indicate a full charge. After 15
seconds the green light and charger will
turn off to save power.
NoTE: If the battery is defective, the red
light on the charger will flash.
The red and green lights will only function
when the charger is connected to both the
battery and wall receptacle.
7 . The charger is a smart charger and can
stay connected to the battery and wall
receptacle for extended periods of time
without fear of damaging the battery or
charger. The charger will automatically turn
on and off periodically to ensure the battery
is fully charged.

BATTERY CARE

The battery in your cordless lawnmower is a
24-volt sealed lead acid system. The battery
can be stored in any position without fear of
leakage.
14 14
• For optimal battery life and performance
the battery should be fully charged every 2
months during storage.
• For optimal battery life and performance
the battery should be fully charged after
each use.
• Store the battery in a cool dry location.
• The battery can be safely stored down to
14°F (-10°C).
• The battery does not need to be fully
discharged before recharging.
• Initially 2 to 3 charging cycles may
be required after purchase to achieve
maximum run time capacity.
The battery is maintenance free and requires
no service. ADDITIONAL BATTERIES can be
obtained from the Customer Helpline 1-866-
354-9679.
ASSEMBLY
imPorTaNT! Before you assemble
the lawn mower, check the accessories
according to the above information, make sure
24V 14" Cordless lawn mower
the accessories are complete.
1. FiTTiNG ThE haNdlE bar (See Fig.
b1, b2,b3)
1) Remove the screws (b) on the both side of
deck. (See B1)
2) Insert the lower handle bar (10) into the
holes on the deck. Be sure to carefully align
the screw holes found on the lower handles
with the screws holes found on the deck
(b). (See fig B1 B2)
3) Secure the lower handle bars to the deck
with the screws (b) provided. (See fig B2)
4) Attach the middle handle (9) with locking
cam lever assembly (8) to the lower
handle(10), and then attach the upper
handle (1) with locking cam lever assembly
(7) to the middle handle (9). (Fig B3)
5) Tightening the two lock cam levers. Check
that the handle is FULLY secured.
The cam lever pressure can be adjusted
by rotating the lock cam lever (7) or (8)
clockwise/counter-clockwise. DO NOT OVER
TIGHTEN. (Fig B4)
NoTE: Ensure the bolts are fully inserted
through the handles before.adjusting or
tightening the cam levers.
6) Attach the cable clips (3) provided, to the
upper handle (1) and middle handle bar
(9). Insert the cable into the clips ensuring
there is enough cable slack to allow the
handlebars to collapse for storage. (Fig.B5)
NoTE: Make sure the cable is routed below
the middle handle. (See B5)
2. GraSS CollECTioN baG aSSEmbly
1) Attach the grass bag handle to the grass
bag assembly as shown in F ig C1-C4.
a. Identify the front and rear of both the
handle and the grass bag assembly. (Fig
C1)
b. Insert the front (I) portion of the handle
into position. (Fig C2)
c. Secure the front portion of the handle in
place by pushing the front portion of the
handle forward (II). (Fig C2)
d. Insert and secure the rear portion of the
handle in position by pushing down on
the back (III) of the handle ensuring it
"clicks" into position. (Fig C2)
EN