Removing A Memory Module - Toshiba Satellite R10 User Manual

Satellite r10/r15 series
Hide thumbs Also See for Satellite R10:
Table of Contents

Advertisement

64
Getting Started
Installing a memory module
11
Replace the screw and tighten it.
12
Turn the computer over and reconnect any cables you
removed.

Removing a memory module

If you need to remove a memory module:
1
Complete steps 1–7 in
page 60
memory module(s).
2
Pull the clips away from the memory module.
The memory module pops partially out of the slot.
to shut down the computer and expose the
Do not try to remove a memory module with the computer
turned on. You can damage the computer and the device.
Do not remove the memory module while the computer is in
Stand By mode. The computer could hang up the next time
you turn it on and data in memory will be lost. In either of the
above cases, the Stand By configuration will not be saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
"Installing a memory module" on

Advertisement

Table of Contents
loading

This manual is also suitable for:

Satellite r15Satellite r10 seriesSatellite r15 series

Table of Contents