Hoover SteanVac Owner's Manual page 12

Remove recovery tank front panel by sliding it straight up.
Replace panel with converter. Slide converter halfway down
opening until it is firmly in place.
Before connecting tube to cleaner,
make sure black tabs are extended
by pulling tan collar toward tube.
Open door on hood labeled "Stair/Upholstery Cleaning
Connection". Press round solution tube connector onto round
projection inside door.
Press connector collar down firmly to ensure that it is fully
connected.
When the solution tube is connected to the deep
cleaner, the nozzle brushes will automatically be
turned off and will not rotate when the deep cleaner is
turned on even if the speed selector is in the HI or LO
position.
12
Using stair/upholstery nozzle
FRONT
PANEL
CONVERTER
SOLUTION
TUBE
Continued
TABS
The tank lid is replaced in a hinge-like manner. Position front
of lid under tabs on front of tank. Rotate lid down onto tank.
Make sure lid is secure on all sides before cleaning.
For full suction, it is important that the recovery
tank lid is properly secured before cleaning.
Reverse procedure to remove hose and solution tube.
Raise deep cleaner handle to upright position.
TAB
NOZZLE CONNECTOR
Attach nozzle to connector end of hose by sliding it onto connec-
tor until the tab locks it securely.
Using your thumb, push forward and up on the latch to remove
nozzle.
Follow the instructions on pages 13 and 14 for the appropriate
cleaning task.
FRONT
LATCH