Table of Contents
Advertisement
To run the coax cable through a wall: Connect the two provided RG-6 cables. Then connect one
end of the cable to the base of the External Antenna. Run the coaxial cable along a descending
pipe or through a wall that leads closest to the location of the Base Unit. Connect the remaining end
of the cable to the Base Unit (See Option 2 on page 9).
Should you need additional cable length, 15 foot extensions (Part #: YX030-15w) are available at
www.zBoost.com. Please note: Cable longer than 65 feet is not recommended.
FOURTH: Connect zBoost Base Unit to
Power
Connect the zBoost Base Unit to the power supply
and plug into a power outlet. When your zBoost
system is in place and fully connected, walk
throughout your home and verify that you are able
to reliably place calls. If the signal strength has
improved, your zBoost is working.
Upon initial power up, the LED will cycle RED,
GREEN and ORANGE for 30 seconds. After 30
seconds, a series of GREEN flashes will indicate
the quality of your setup. Following this, a solid
GREEN light indicates normal conditions. If it is not
solid GREEN, follow the instructions in the Base Unit
LED Indicators section. Adjustments may be needed
to optimize performance. If you find the increased
signal coverage is acceptable, however, no
additional adjustments are needed. See "Base Unit
Light Indicators" on page 11 for more information.
Antenna Aiming
To get the maximum benefit, you will want to take
special care to make sure you point the antenna in
the direction of the best signal for your wireless service provider. You may wish to use a YX699 RF
signal meter to help during this process or try our zBoost Signal Finder Android App. The majority of
the time a cell tower will hold more than 1 frequency band and/or service provider.
To aim the antenna for maximum signal, you will need a phone operating on the same wireless
network(s) in use at the install location.
Note: A 1 dBm increase is 25% gain in signal strength.
If you do not know which direction the best signal is coming from, once the unit is installed, rotate
the External Antenna in 90 degree increments while measuring the results inside the desired
coverage area.
1.
Place the cell phone(s) on a non-
metal surface about 6-8 feet from
the Base Unit.
2.
Turn the signal booster on
and wait 30 seconds. Note the
number of signal bars displayed
on your cell phone. For best
results, you want to place your
phone where the phone's signal
meter displays in the middle of
the signal meter range or less
so that it can indicate as you
zBoost
SOHO Premium ZB645SL Manual
®
zBoost Base Unit
Coaxial Cable
Power Supply
Base Unit Assembly
7
Indoor Antenna
RG-6 (15ft)
TNC-F Adaptor
Wall Mounting
Bracket
Advertisement
Table of Contents
