Table of Contents
Advertisement
rotate the External Antenna to the optimum direction. If it is reading too high, move the
phone farther from the Indoor Antenna. (Note: if you're using signal bars to measure signal
strength, turn off your LTE during this process)
3.
Record the number of signal bars or dBm________(A) on your cell phone. You can use
our YX699 RF Signal Meter or an application on a smart phone to get the dBm. Leave the
phone in exactly the same place and pointing in the same direction for the following steps.
Note the direction External Antenna starting position ________________.
4.
Rotate the External Antenna 90 degrees and then record the phone signal bars ______(B).
5.
Continue to rotate the antenna another 90 degrees in the same direction and record the
phone signal bars _________(C).
6.
Again, rotate the antenna another 90 degrees in the same direction and again record the
phone signal bars _________(D).
7.
If you desire to optimize further, then look for the two highest signal bar readings above and
move the antenna between these two points to find the highest signal bars reading.
8.
Look for the highest reading above. Set the antenna to that position and tighten the antenna
to the mast of your choosing. We suggest PVC pipe that is at least 1.5" or J-Pole (part #
YX014, not included).
Note
Before drilling any holes into a wall to run your cable,
make sure you know where existing electrical wiring is
located. Drilling into live electrical wiring could cause an
electrical shock and sever the wire.
zBoost
SOHO Premium ZB645SL Manual
®
8
Advertisement
Table of Contents
