Problem Solving - Angelcare AC1100 Instruction Manual

PROBLEM SOLVING

FALSE ALARMS
• Turn off the Nursery Unit.
• Verify the connection between the Sensor Pad and Nursery Unit. Unplug and reconnect the cord.
• Make sure there is no bedding between mattress and Sensor Pad. If the crib has a spring or slat base, place a hard board
between the crib base and the sensor pad measuring at least 13" x 13" (33x33 cm) and 1/4 inch (6 mm) thick.
• Make sure Sensor Pad is positioned as described under the Installation in the Baby's room section. Sensitivity may need to
be adjusted, refer to the Movement section.
ALARM WILL NOT SOUND
• Avoid contact with the crib when the monitor is ON.
• Place crib near a solid supporting wall to avoid Sensor Pad from detecting movement from outside crib.
• You may need to decrease the sensitivity, refer to the section Testing your Angelcare
NO SOUND IS BEING TRANSMITTED
• Bring Parent Unit closer to Nursery Unit.
• Check/replace batteries or recharge Parent Unit.
• Check connections or change to another electrical outlet.
• Ensure both units are ON.
• Check on the top bar of the Parent Unit to see if the Monitor is on "MUTE" instead of "ON". Refer to the Sound Section.
NURSERY UNIT POWER ON INDICATOR (GREEN LIGHT) DOES NOT LIGHT UP
• Check connections or change to another electrical outlet.
• Push and hold the left wing for 2 seconds to turn the Nursery Unit ON.
WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface away from baby's reach.
• Replace the batteries or recharge Parent Unit.
STATIC, DISTORTION, INTERFERENCES (FROM OTHER MONITORS, WIRELESS PHONES, WALKIE-TALKIES, ETC...)
• Rotate Parent Unit or move it away from source of interference.
FEEDBACK (LOUD NOISES EMITTED FROM THE PARENT UNIT)
• Move units farther apart (at least 3 meters/10 feet apart).
• Decrease volume on Parent Unit.
THE PARENT UNIT SCREEN IS BLACK (PARENT UNIT IS OFF)
• Turn the Parent Unit back ON by pushing and holding the power key for 2 seconds.
• Replace the batteries or recharge Parent Unit.
If you experience a problem that is not noted in this manual, please do not return the product to the store.
United States and Canada : please contact us at: angelcare@cdecinc.ca
If you are not completely satisfied or have any questions:
Other countries : please contact your local Distributor.
We may have a simple solution to your problem.
19
Monitor and the Movement section.
®
E
N