Angelcare AC1100 Instruction Manual page 10

C. INSTALL THE NURSERY UNIT AND SECURE ALL CORDS
D. INSTALLATION OF THE SENSOR PAD UNDER THE MATTRESS
Sensor Pad(s) 1 or 2
E
N
• Position the sensor pad as shown above. Make sure the printed side faces up. Do NOT place any bedding between the mattress
and the sensor pad.
• Secure the sensor pad cord to crib using a tie wrap. Run the cord on the floor to ensure it is out of the baby's reach.
•The Sensor Pad must rest on a completely flat and firm surface. If the crib has a spring or slat base, place a hard board between
the crib base and the Sensor Pad measuring at least 13" x 13" (33x33 cm) and 1/4 inch (6 mm) thick. Make sure the sensor
pad's cord passes underneath the mattress as shown above.
• The sensor pad works with all baby bed sizes and all mattresses, except memory foam mattresses.. You will have to test your
sensor pad on STEP 13.
• Once you are done using the Sensor Pad, please remove it from the baby's crib and store it away.
• The Angelcare movement monitor is not designed for use with adults, children or infants older than 24 months.
IMPORTANT
Keep at
least 1m
(39 inches)
apart
WARNING
STRANGULATION HAZARD - Children have STRANGLED in cords. Keep the
adapter cords and sensor pad cord out of the reach of children. Do not put the
Nursery Unit inside a crib or play yard. Because of the serious strangulation risk
to infants and toddlers, parents and caregivers should never place the nursery
unit within 3 feet (1 meter) of a crib. NEVER use extension cords with AC
adapters. ONLY use the AC adapters provided.
1. Unscrew the bottom of the Nursery
2. Connect the AC adapter to Nursery
3. Connect the Sensor Pad cord to the
4. Turn the Nursery unit ON by pushing
POSITION OF SENSOR PAD UNDER MATTRESS
I sensor pad
Crib center
10
Unit and insert 3 AAA regular
alkaline batteries.
Unit and plug adapter to an electrical
outlet.
Nursery Unit.
and holding the left wing for 2
seconds.
2 sensor pads
(On some models)
Crib center