List Of Parts - Minelab Excalibur II Instruction Manual

List of Parts

6
Headphones
Control Cylinder
Finds Bag
(US, UK & Europe only)
Short Lower Shaft
(Useful for diving)
Long Lower Shaft
Slimline Coil (8" or 10")
(with Skidplate)
Armrest
Upper Shaft
Battery Pod
(includes NiMH cells)
Charger Adaptor Plug
and Cap
Mains Charger
Nylon Bolts (2)
Wingnuts (2)
Rubber Washers (4)
Warranty Card
Instruction Manual
Assembly
Attaching the Armrest to the Upper Shaft:
If not already bolted to the upper shaft:
1 Ensure that the cup of the armrest is pointing in
the same direction as the handle. Slide the armrest
onto the end of the upper shaft aligning the shaft
and armrest holes.
2 Insert the short bolt through the armrest and
upper shaft holes.
3 Fasten the wing-nut onto the bolt.
Attaching the Control Cylinder to the Upper shaft:
If not already clipped to the shaft:
1 Compress the lower spring loaded pin of the
upper shaft.
2 Ensure that the coil cable of the control cylinder is
pointing downwards. Slide the control cylinder onto
the upper shaft until both pins are compressed and
they reach the adjustment holes. The pins will spring
out and clip into place.
7