AEG DVD 4619 HC Instruction Manual page 63

Dolby Digital Setup
05-DVD 4619 HC_GB.indd 63 05-DVD 4619 HC_GB.indd 63
3D Process
NOTE:
This device does not make use of the „PL 2" function and therefore
cannot be selected.
Reverb Mode
With the "Reverb Mode" function it is possible to produce surrounding
acoustics similar to those found in a concert hall or church.
Dual Mono
The Audio output is normally in stereo. Here you have the possibility to
choose Mono-output instead of Stereo-output.
Stereo: The Audio output is in Stereo (default).
L-Mono: The Audio output is in Mono. In this case the signal of the
"left" stereo channel is transmitted to all speakers.
R-Mono: The Audio output is in Mono. In this case the signal of the
"right" stereo channel is transmitted to all speakers.
Mix Mono: The Audio output is in Mono. In this case the signal of the
"both" stereo channel is transmitted to all speakers.
NOTE:
By pressing the L/R / ST/MO button (Fig. 3/35) you can also switch
between the sound output options.
Dynamic
The term "Dynamic" (Dynamic Range) describes the ratio of quietest and
loudest sound. If the dynamic range is very large, you will experience very
quiet and very loud sounds.
This may cause replay problems. Let us assume that you are watching a
DVD in a relatively loud environment. You can now increase the volume to
be able to hear also the very quiet passages, however with the disadvan-
tage that loud passages will be unacceptably loud. In this case it would
make sense to compress the dynamic range (i.e. reduce) and increase the
output volume at the same time.
FULL -1/8: The dynamic range is compressed slightly (1/8) to full (FULL).
OFF: The dynamic range is not compressed at all (default).
English
63
28.05.2009 8:09:00 Uhr 28.05.2009 8:09:00 Uhr