Maintenance; Troubleshooting; Accessories - Delta 36-725 Instruction Manual

To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or servicing, before
installing and removing accessories, before adjusting and when making repairs. An accidental start-up can cause
injury.
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry
compressed air. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve or otherwise
LUBRICATION & RUST PROTECTION
Apply hardwood flooring paste wax to the machine
table occasionally or use a commercially available
protective product designed for this purpose. Follow
the manufacturer's instructions for use and safety.
MAINTENANCE REMINDERS
Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
Specific areas which require regular maintenance
include:
RIVING KNIFE CLAMP PLATE: Keep this area free of
dust and debris buildup. Blow out area regularly with
compressed air.
NOTE: If the riving knife clamp can't move freely,
have the saw serviced by authorized DELTA
Equipment Corporation service center personnel.
For assistance with your machine, visit our website at
or call DELTA® Power Equipment Customer Care at 1-800-223-7278.
FAILURE TO START
If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the
receptacle, and check reset button on power switch housing. Also, check for blown fuses or open circuit breakers in
your power line.
A complete line of accessories is available from your DELTA
and DELTA Factory Service Centers, and DELTA
®
www.DeltaMachinery.com for an online catalog or for the name or your nearest supplier.
Since accessories other than those offered by DELTA
use of such accessories could be hazardous. For safest operation, only DELTA
accessories should be used with this product.

MAINTENANCE

damage the material.
Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
To clean cast iron tables of rust, you will need the
following materials: a medium sized scouring pad, a
can of spray lubricant and a can of degreaser. Apply
the spray lubricant and polish the table surface with
the scouring pad. Degrease the table, then apply the
protective product as described above.
WORM GEARS: Keep the worm gears free of dust
and debris buildup. Blow out area regularly with
compressed air. Use a lithium-based multipurpose
grease as needed on these gears.
CLEAN SAWDUST BUILDUP OUT OF CABINET
PERIODICALLY: NOTE: Debris can also be removed
from the saw from below the throat plate, inside the
dust port.
®
Power

TROUBLESHOOTING

www.DeltaMachinery.com

ACCESSORIES

Authorized Service Centers. Please visit our Web Site
®
31
for a list of service centers
Supplier, DELTA Factory Service Centers,
® ®
have not been tested with this product,
®
recommended
®