Front And Rear Rails; Fence Guide And Power Control Box - Delta 36-725 Instruction Manual

FRONT AND REAR RAILS

1. Attach the front rail halves (2" X 2" angles
36 ¾" and 20" long) to the table front and
extension wings. Align the holes (A) in the
front of the table top with the holes (B) in
the left (short) and right (long) sections of
the front rail, as shown in Figure 5, and
attach using four 5/16-18 x 1 1/8-inch flat
head screws, 5/16 lock washers and 5/16-
18 hex flange nuts.
2. Attach the rail union plate (C) using two m5
x 16 shoulder bolts and m5 nylock nuts in
the two holes where the rail sections meet.
3. Use supplied rail alignment gauge to ensure the
rails are the proper distance from the top of the
table. See Figure 6. The front rails have holes on
both surfaces of the rail for attachment to both the
table and the fence guide.
4. Attach the rear rail halves to the table with four
5/16"-18 hex screws and lock washers. Use the
slot in the supplied gauge to ensure the rail is the
proper distance from the top of the table.
5. Attach the spreader bar (D) to the outboard end of
the front and rear rails using m8 x 16 shoulder bolts
and m8 nylock nuts. See Figure 5.
FENCE GUIDE AND POWER
CONTROL BOX
1. Connect the two halves of the fence guide (A and B)
by inserting the smaller end into the larger end. See
Figure 7.
2. Attach the fence guide to the front rail using five
1/4-20 x 1/2-inch hex button head screws and
¼-inch spring washers through the holes (C) on the
bottom side of the front rail.
3. Align the two holes in the power control box
bracket with the holes underneath
the front rail (D), located on the
left side of the saw. Secure the
power control box to the front
rail using two1/4-20 x 1/2-inch
button head screws.
4. Fix the hanging power cord at
rear side of front rail by wire
clip and M5 x 6mm round head
cross screw.
ASSEMBLY
(continued)
D
12
FIGURE 5
Gauge
Table
Table
Rail Rail
Back
FIGURE 6
A B
FIGURE 7
Gauge
Front
C