B. T
O
O
PERATE FROM THE
•
Make sure that the safety lanyard and/or chain
stop are removed from the anchor chain.
•
Lift protective cap on foot switches at port bow
and depress UP or DOWN switch for the
desired result.
C. T
O
M
O
PERATE
ANUALLY
•
Make sure that the safety lanyard and/or chain
stop are removed from the anchor chain.
•
Insert the emergency handle (located in the stbd
bow locker) into the clutch nut.
•
Turn handle clockwise to retrieve anchor.
!
Make sure that the power is off before any work is
performed on the windlass.
D. M
:
AINTENANCE
•
Periodically check the motor and control box
electrical connections, remove any residue and
W
(M
INDLASS
AINTENANCE
(F
. 3.16.1)
IG
CLUTCH NUT
DRUM
UPPER CONE
CHAIN PULLEY
LOWER CONE
3.16
S
3 • U
ECTION
B
:
OW
:
DANGER
P
)
ROFILE
EMERGENCY HANDLE
Y
B
SING
OUR
cover the connections with a small coating of
grease.
It is recommended at least once a year to
disassemble the windlass and remove any residue
buildup.
•
Using the emergency handle ( located in the
bow locker), unscrew the clutch nut by turning
the handle counterclockwise.
•
Remove the drum, upper cone, chain wheel and
lower cone.
•
Wash down with fresh water and remove any
residue.
•
Coat contact surfaces with a light film of
lubricant.
•
Reassemble the unit and tighten clutch by
turning the handle clockwise.
NOTE: Use the fresh water washdown spigot in
the port bow locker to hose down the chain in the
locker after haul-in.
REFER TO WINDLASS OPERATOR'S MANUAL IN YOUR
OWNER'S PACKET FOR DETAILED OPERATING
INSTRUCTIONS.
21. B
T
OW
HRUSTER
The bow thruster is electrically driven and gives
the operator more maneuverability of the bow when
docking or maneuvering the vessel in narrow
channels or where space is at a premium.
T
O
O
PERATE THE
•
Activate the bow thruster by turning the 24V
BOW THRUSTER switch ON. The switch is
located on the control station (See figure 2.10.1
& 2.10.2)).
•
By manipulating the joy stick also located on
OAT
(O
)
PTIONAL
B
T
OW
HRUSTER
390 Sundancer
®
( 425 Sundancer
®
)