Maintenance And Care Instructions - HoMedics SOUNDSPA PREMIER Instruction Manual And Warranty Information

Remote Sensor Battery Installation:
1. Loosen the 4 screws securing the battery cover with a small
screwdriver (included) and remove. Insert 2 alkaline AAA batteries
according to the polarity direction indicated.
2. Place the home receiver (SoundSpa Premier) as close as possible
to the remote sensor. This will help with synchronization between
the two units.
NOTE: Once you are ready to position your remote sensor
and home receiver, ensure that the distance is not outside the
effective transmission range (100 feet). Some building materials
and location of the home receiver or remote sensor can affect
transmission quality and range. Try various locations for best
results.
3. Press the C/F button inside the remote sensor to change between
º º
C and F. (The remote sensor is preset on
4. Press the TX button inside of the remote sensor to verify the
reception.
5. Replace the cover and tighten the 4 screws.
NOTE: It is recommended to test the units next to each other
to ensure that both the remote sensor and home receiver are
properly synchronized.
Remote Sensor Mounting Instructions
The Remote Sensor comes with a table stand or can be wall mounted.
Table Stand -
Simply fold out the attached stand from the mounting bracket.
Wall Mounting -
Set a screw in the desired hanging location and mount.
NOTE: Keep the remote sensor out of direct sunlight and rain.
Do not mount on metal surface.
º
F.)
1 2
Remote Sensor Low Battery Indication
Low battery indication is available for the remote sensor. A battery life "
will display on the remote sensor. Replace the batteries as necessary and follow the
setup procedure.

MAINTENANCE AND CARE INSTRUCTIONS

• Extreme temperatures, shock or areas of unusual vibration should be avoided
to prevent damage to the units.
• Clean the units using only a soft, damp cloth to wipe. Do not use solvents,
abrasives, detergents or other strong cleaning agents. After cleaning, wipe
surfaces with a dry cloth.
• Do not submerge units in water or other liquids.
• Do not subject the units to extremely severe temperatures - DO NOT
PLACE UNITS INTO OVENS, FREEZERS or MICROWAVE UNITS.
NOTE: Opening the housing (other than the battery compartment) of the
Remote Sensor or the SoundSpa Unit will invalidate your warranty. Do
not attempt to repair this unit - There are no consumer serviceable parts.
" icon
1 3