Table of Contents
Advertisement
7.Special Functions
7. Special Functions
7.1
Repeater-Access
1. In the VFO/Memory/Call channel mode, select the channel to which you wish to
apply the Repeater-Access setting.
2. Press the FUNC key, and while
The Repeater-Access setting is applied to the operating frequency.
NOTE:
Preset parameters on the Repeater-Access function memory will be effective at
any frequency. Repeater-Access parameters have priorities over the parameters
programmed in the VFO/memory/CALL modes.
Reverse operation is possible by pressing the
The repeater function releases temporary and you can transmit on the frequency
originally used for the repeater downlink while monitoring the uplink frequency.
Press
The
7.2
Program Scan
7
This is a type of VFO scan, but by setting the frequency range of the VFO into PH and
PL channels, it only scans between those frequencies.
With setting the PH and PL properly, up to 3 Program scan ranges will be available.
1. Enter the Memory mode and set the PL and PH
frequency into the designated memory channels.
Refer to Memory setting for the proper sequence.
2. Return to VFO mode by pressing
the VFO to the frequency within the range to be
program-scanned.
3. Press the
scan mode, "P" flashes after memory channel
display.
4. Press any key other than the MONI key to stop
scanning.
42
again to go back to the normal repeater mode.
icon flashes during the reverse operation.
key to start scanning.During this
is displayed on the LCD, press the
key.
Range (1)
key. Set
key.
The Highest band edge
PH
(2)
PL
(3)
The Lowet band edge
Advertisement
Table of Contents
