Daewoo KOC-1C0KB Service Manual page 29

5. BLOWER MOTOR AND CONVECTION MOTOR
1) Remove a connector from the motor.
2) Measure resistance between two terminals like as following figure.
3) Reading of blower motor is 60Ω and convection motor is 270Ω .
4) It is normal to stop convection motor smoothly, when door is open during convection mode.
=> You can see the motion of convection motor,
Measuring
point
BLOWER MOTOR
6. HEATER (TOP HEATER, REAR HEATER, HALOGEN HEATER)
1) Remove a connector from the heater
2) Measure resistance between two terminals like as following figure.
3) Normal readings of top heater, rear heater and halogen heater are 36Ω, 36Ω, 23Ω.
4) The oven should be cooled enough to measure resistance of the heater.
TOP HEATER
7. NOISE FILTER
1) Remove a connector from the noise filter.
2) Check each continuity of N-N and L-L terminal like as following figure.
3) It should be normal to keep continuous continuity.
Measuring
point
Measuring
point
CONVECTION MOTOR
Measuring
point
REAR HEATER
28
Measuring
point
HALOGEN HEATER
L-L
N-N