7. TO REMOVE MAGNETRON
1) Remove a screw which secure the magnetron.
2) Remove the magnetron.
3) Reverse the above steps for reassembly.
NOTE: Never install the magnetron without the metallic gasket plate which is packed with each magnetron to
prevent microwave leakage. Whenever repair work is carried out on magnetron, check the microwave
leakage. It shall not exceed 4mW/cm2 for a fully assembled oven with door normally closed.
Metallic
gasket
plate
Cooling fin
Filament
terminal
<MAGNETRON>
Magnetron
antenna
19
Wave guide Magnetron antenna
Metallic gasket plate