Water Supply Inlet - Hitachi BD-W3300 Operating Instructions And Owner's Manual

Water supply inlet

Clean the water supply inlet if water supply is not smooth.
Close the tap, and disconnect the water supply hose.
 To prevent water from spilling, perform the following.
Close the tap, and press
Press to select the [TUB CLEAN] program.
Press to start.
Run the operation for about 10 seconds, press
then press
Loosen the union nut and remove it.
Remove any debris from the water supply inlet's filter using
a toothbrush or similar tool.
 Remove the water supply inlet's filter using pliers before cleaning it.
 After removing the water supply inlet's filter and cleaning it, be sure
to reattach it. Failure to do so may result in damage to the water
valve.
Reconnect the water supply hose properly.
(Installation Instructions)
 Failure to do so will result in water leakage.
to turn on the power.
to turn off the power.
Close
Union nut
, and
Water supply inlet filter
Water supply inlet filter
77