Water Supply Inlet · Drain Outlet · Door · Drum - Hitachi BD-W3300 Operating Instructions And Owner's Manual

Front loading washer dryer
Hide thumbs Also See for BD-W3300:
Table of Contents

Advertisement

Symptom
 The fan rotation speed is adjusted during
drying operations, causing the sound to
Unusual sounds
fluctuate.
occur during
drying operations.
 The drum rotates at high speeds during drying
operations.
Is the machine stable and level?
Are there hairpins, coins, or foreign objects
inside the drum?
Are the transport bolts attached?
Unusual vibration
and noise occurs.
 The drums of front loading washers rotate
horizontally. This transfers more vibration to the
floor when compared to top loading washers.
 The drum gradually accelerates during the spin
cycle. The sound will get louder as the rotation
speed increases.
The drain outlet
 This is the sound of moist air being expelled
makes a noise
during drying
during drying operations.
operations.
The noise
 This is the sound of the machine checking
increases after the
whether the fan is operating.
operation finishes.
Water flow can
 After a drying operation finishes, water is
be heard after the
discharged to the drain outlet to prevent
drying operation
backflow of odors from the drainage pipe.
finishes.
Is the tap open? Did a water outage occur?
Is the water supply inlet's filter clogged?
Water is not
Is the water supply pipe or water supply hose
supplied.
frozen?
 If you started from a rinse operation, water is
supplied after drainage/spin operation.
Does the shape of the tap match the hose?
Are the one-touch joint and union nut loose?
The water supply
hose leaks.
Is the tap leaking?
 After years of use, the gasket on the tap may
degrade or rust and eventually result in water
leakage.
Possible cause
Solution
This is not a malfunction.
You can adjust the spinning speed during the dry
cycle of [WASH DRY] operations and set it to Low-
Speed Mode.
(P. 68)
Make sure the air bubble in the supplied spirit level
is inside the circle.
(Installation Instructions)
Remove any objects.
Remove the transport bolts.
(Installation
Instructions)
This is not a malfunction.
You can adjust the startup operation for spinning
and set it to Low-Vibration Mode.
This is not a malfunction.
This is not a malfunction.
This is not a malfunction.
This is not a malfunction.
Make sure the tap is open.
Remove any debris.
(P. 77)
Check the water supply pipe and water supply
hose.
(P. 97)
This is not a malfunction.
Check the tap.
(Installation Instructions)
Check the water supply pipe and water supply
hose.
(Installation Instructions)
This is not a malfunction.
(P. 68)
83

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents