Focusing The Camera; Troubleshooting; Fcc Complicance - Interlogix Camera Installation Manual

3. Tighten all pivot screws. Secure the screws with blue
Loctite.

Focusing the camera

The camera has a varifocal lens (2.9 to 8 mm) and can
also be adjusted for focus. To focus the camera, do the
following:
1. Access live look-in mode to see the camera's field-
of-view.
2. Turn the camera cover counterclockwise to remove
the camera cover from the camera base (Figure 10).
Figure 10: Removing the camera cover
3. Loosen the zoom ring thumbscrew (Figure 11).
Figure 11: Adjusting focus and zoom settings
4. Turn the zoom ring to set the desired field of view.
5. Tighten the zoom ring thumbscrew.
6. Loosen the focus ring thumbscrew (Figure 11).
7. Turn the focus ring to set the desired focus.
8. Tighten the focus ring thumbscrew.
4
Note: To keep the camera in focus, you may have to
adjust the focus ring while you tighten the
thumbscrew.
9. Reattach the camera cover.
10. Make final adjustments to the angle of the camera
assembly and secure all screws with blue Locite.
See Adjusting the camera angle.
11. Disconnect the test kit or laptop computer.

Troubleshooting

• There is no video or it is intermittent.
The BNC connector is probably shorted or the wires
are pinched.
Ensure that the BNC connector inside the
connection box is wrapped with electrical tape to
prevent metal-to-metal contact with the camera
housing (Figure 8).
Ensure that the pigtail wires coming from the camera
are not pinched in the hinge.
• Video is upside down or misaligned on the monitor.
The camera is not inverted or aligned. Invert and/or
align the camera. See Mounting the camera from
below on page 1.
• Video is shaky on the monitor.
There is excessive vehicular vibration of the camera.
Reinforce the mounting surface with a tapping plate
placed behind the mounting surface to minimize
vibration.

FCC Complicance

This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the installation
instructions, may cause harmful interference to radio
communications.
You are cautioned that any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
Forward Facing Camera Installation Manual