The I/O board will send a command to the lift motor in three circumstances
(Motor is running):
1) The switch „Stack mode/Single sheet feed" is off (single sheet feed). The motor drive the plate
upwards till its pin triggers the top microswitch. Lifting the initial feed rollers, which triggers the forked
photocell (LED is lit) also stops the motor.
2) The switch „Stack mode/Single sheet feed" is on (stack mode), the "Start/Stop" switch is on (Start:
LED green) and the paper sensor detects one document. The motor will run till the forked photocell is
activated.
3) The switch „Stack mode/Single sheet feed" is on (stack mode) and the paper sensor detects no
document (end of stack). The motor will run till the lower microswitch is activated. Again, if the initial feed
rollers are lifted the motor will stop.
®
SCAMAX
Tech. Manual 06/2002
T-55
2600/4000