InoTec SCAMAX 2600 Service Manual page 38

The following picture shows the endorser processor board:
Flash-Plug
Plug
Photocell
LED Indicator
Photocell
Printhead
Main Plug
(optional)
Parameters can be changed by using the PDIAG program. To achieve this the PC's COM1 or COM2 port
is connected to the processor board's RS232 port and the PDIAG program started. Remove the 10-pin
plug of the ribbon cable from the controller. To restore all settings to the original factory settings load the
file INOTEC.EEP by pressing F5. Subsequently pressing F2 transferres these values to the endorser.
Caution: Only change the parameters described below!!!
®
SCAMAX
2600/4000
Tech. Manual 06/2002
RS 232 (TTL)
to Controller
+5V
GND
+38V
+12V
GND
RS 232
for PDIAG
T-38