Unscrew the IC support plates and mark the position of the CCD sensor on the board mounting plate.
IC support plates
Plug the new CCD sensor into the IC socket on the board and align to the previously marked position.
CAUTION! Check polarity.
Fasten IC support plates. The new CCD sensor must be absolutely free from dust and grease. Clean it.
Insert the complete camera unit into the adjustment frame, ensuring the springs are forward. Check that
springs are not bent. Compress the springs sufficiently to ensure the board mounting plate seats properly
behind the set-screws. Fasten fixing bolts, then undo them again a quarter of a turn. The camera should
now be movable within the adjustment frame.
Camera adjustment
frame
®
SCAMAX
2600/4000
Board mounting plate
Set-screws (A+B)
Tech. Manual 06/2002
CCD sensor
Set-screw ( C )
T-20