Entering The Mob Mark - Furuno GP-90 Operator's Manual

3.6

Entering the MOB Mark

The MOB mark denotes man overboard
position. To mark man overboard position,
press the [EVENT MOB] key. When the key is
pressed, the position at the exact moment the
key is pressed automatically becomes the
destination. Further, the Plotter 1 display
replaces the display in use when it is other
than a plotter display.
Only one MOB mark may be entered, and
each time the MOB mark is entered the
previous MOB mark and its position data are
written over.
1) Press the [EVENT MOB] key for at least
three seconds.
The MOB mark ("M") is entered at the
MOB position and the message shown in
Figure 3-7 appears.
Saved MOB position
Are you sure to change course
to MOB position ?
ENT: Yes MENU: No
Figure 3-7
3-4
2) Press the [NU/CU ENT] key. If the display
in use is Highway, Navigation or Data,
they are automatically replaced by the
Plotter 2 display.
Note: You may cancel MOB position as
destination by pressing the [MENU
ESC] key instead of the [NU/CU ENT]
key at step 2. Note that the MOB mark
remains on the display.
Erasing MOB mark
To erase a MOB mark, you must first cancel it
as a GOTO waypoint and then erase all
marks.
1) Press the [GOTO] key.
2) Press the [5] key to choose 5. Cancel.
3) You are prompted to release GOTO;
press the [NU/CU ENT] key.
4) Press the [MENU ESC] key to open the
menu.
5) Press the [3] key to choose 3. ERASE
TRACK/MARK.
6) Press to choose Erase Mark.
7) Press to choose Yes.
8) Press the [NU/CU ENT] key.
9) Press the [MENU ESC] key.