Detergent/Rinse Module - GE GLDT690T Technical Service Manual

Detergent/Rinse Module

The control panel must be removed to access the
detergent/rinse module. (See
The detergent/rinse module is connected by 2 wires
and held in place by 6 Phillips-head screws and 2
brackets.
The detergent/rinse module operates on 120 VAC
and has an approximate resistance value of 2 K
The detergent/rinse mod ule au to mat i cal ly
dis pens es both the de ter gent and the rinse agent at
the ap pro pri ate times. The module is activated twice
during a wash cycle. Detergent is dispensed at the
beginning of the main wash cycle and rinse agent at
the beginning of the fi nal rinse.
Operation of the detergent/rinse module can be
checked by using the service test mode. (See
.)
Test Mode
The fi rst time the module is activated, the lever
slides up the right-hand path of the connecting rod
(1). This action releases the de ter gent cover.
)
Control Panel.
Bracket
Bracket
Disconnect
Disconnect
Service
When deactivated, the lever returns down the left-
hand path and comes to rest under the notch (2) in
the center of the connecting rod.
At the second activation, the lever lifts the
con nect ing rod by the notch. This action lifts the
rinse dispenser plunger (3) and re leas es the rinse
agent. When deactivated, the lever returns to its
original start ing position.
Note: Make sure the rubber seal is retained in the
recessed groove before reinstalling the module to
the door assembly.
– 19 –
1
2
3
Seal