Door Switch Assembly - GE GLDT690T Technical Service Manual

7. Remove 2 Phillips-head screws from the display
PCB user interface board.
To remove the power board assembly:
1. Disconnect the power supply to the dishwasher.
2. Remove the control panel. (See
3. Remove the 2 Phillips-head screws that attach
the power board cover to the power board.
4. Disconnect the wire harnesses from the power
board.
5. Remove the 2 Phillips-head screws that attach
the power board assembly to the housing.
Disconnect

Door Switch Assembly

The door switch assembly consists of 2 switches
activated by a spring-loaded plunger. One door
switch connects or disconnects the line (hot) side of
120 VAC. The other switch connects or disconnects
the neutral side of 120 VAC.
WARNING: Power remains applied to the controller
location at CN1, Pin 1 to 3, while the door is open
(unlatched).
When the door is in the closed position, the door
latch presses and holds down the switch plunger
on the door switch assembly. This action holds the
door fi rmly against the seal, and the normally open
contacts of the door switches are closed.
.)
Control Panel
To remove the door switch assembly:
1. Disconnect the power supply to the dishwasher.
2. Remove the control panel. (See
3. Disconnect the 4 wiring harnesses from the door
4. Remove the 2 Phillips-head screws that hold the
– 18 –
switch.
door switch assembly to the control panel.
.)
Control Panel