GE Profile PTDS650EM Technical Service Manual page 10

About the control settings.
STEAM REFRESH For slightly wrinkled dry garments. Significantly reduces wrinkles. After the STEAM REFRESH
( on some models) Cycle, the unit will beep (if Signal is selected) and display "00."
Steam Refresh Large is recommended for 3-5 garments and Small for 1-2 garments.
NOTE: Steam cycles are not intended for use with towels.
NOTE: A single extremely light fabric item may need to have an additional item included in =
the STEAM REFRESH cycle to achieve optimum results.
Important - the temperature setting must be set to HIGH and water must be turned on
before running the STEAM REFRESH cycle.
STEAM For use with larger loads than STEAM REFRESH. Ideal for loads left in dryer for an extended
DEWRINKLE time.
(on some models) STEAM DEWRINKLE Large is recommended for 8-13 garments and Small for 6-7 garments.
NOTE: Steam cycles are not intended for use with towels
Important! - the temperature setting must be set to HIGH and water must be turned on
before running the STEAM DEWRINKLE cycle.
F
START—
Close the dryer door. Press START. Opening the door during operation will stop the dryer. To restart the
dryer, close the door and press START to complete the cycle. If the dryer is running, press once to pause the cycle;
press again to continue the cycle. If the dryer is paused for more than 24 hours, the cycle will be cancelled.
To stop the cycle, hold the button for 3 seconds.
NOTE: Drying times will vary according to the type of heat used (Electric, Natural or LP gas), size of load, types
of fabrics, wetness of clothes and condition of exhaust ducts.
G
Wrinkle Care
Use this option to minimize the wrinkles in clothes. It provides approximately 15 minutes of no-heat tumbling
after the clothes are dry.
This option can only be used with the COTTONS, EASY CARE and DELICATES cycles. If you are using CYCLE
SIGNAL and you select the WRINKLE CARE option, a signal will sound at the end of the drying time and several
times during the WRINKLE CARE cycle. This will remind you that it is time to remove the clothes.
If WRINKLE CARE is not ON, the dryer will stop once the timer reaches the WRINKLE CARE mark on the cycle dial.
– 10 –