Napco - Gemini GEM-RP1CAe2 Operating Manual

The GEM-RP1CAe2 is a "smart" user-
friendly, menu-driven keypad designed for
your Napco control panel. The keypad is
interactive. Its alphanumeric screen will not
only display the status of your system, but
will also give you step-by-step instructions to
guide you through all operations.
This booklet contains
information about the operation of your
system with this GEM-RP1CAe2 Keypad.
Read it carefully and keep it handy for future
Test your sounding device and backup battery
(This test should only be performed on weekends or at a time designated
by your alarm company.)
1. While disarmed, press A
.
2. Answer NO (press F
) until "ACTIVATE BELL TEST" appears in the
window.
E
Press YES ( ) to execute the test. The alarm will sound for about two
seconds.
•
If the alarm does not sound, call for service.
•
If the battery is low, "LOW BATTERY E02-00 SERVICE" will appear
in the display indicating a low battery condition. Allow 24 hours for
the battery to recharge. If the trouble continues, call for service.
2
I N T R O D U C T I O N
reference. Check the Glossary for an
explanation of terms that may be unfamiliar
to you.
You'll probably find subjects mentioned
in this booklet that do not apply to your
system. Napco control panels have such a
wide variety of features that few security
important systems, if any, will ever need them all. Your
alarm professional has chosen appropriate
features for your particular needs.
IMPORTANT - TEST YOUR SYSTEM WEEKLY
Regardless of how your system has
been configured, rest assured that it has
been carefully designed and engineered to
the highest industry standards. To assure
optimum safety and security, familiarize
yourself with this equipment. Periodically
check its condition and state of readiness by
testing it at least once a week in both the ac/
battery and battery-only modes (ask your
alarm professional how to make these tests).
Test your central station communicator
1. Notify your Central Station of the impending test. While disarmed, enter
A
your User Code and press .
2. Answer NO (press F
) until "ACTIVATE DIALER TEST" appears in
the window.
3. Press YES ( E
) to send a test code to the central station.
•
If the test is not successful, "COMM FAIL E03-00 SERVICE" will
display, indicating a communication failure. Call for service.
Note: Any subsequent successful transmission will clear a "Failure to
Communicate" system trouble.