Turning Off The Alarm (Disarming) When Returning - Gemini GEM-RP1CAe2 Operating Manual

T U R N I N G O F F T H E A L A R M ( D I S A R M I N G ) W H E N R E T U R N I N G
E N T R Y T I M E X X X
D I S A R M S Y S T E M
I N V A L I D E N T R Y
T R Y A G A I N
* * * * * * * *
A L A R M
0 2 - B A C K A L A R M
0 3 - L I V I N G R O O M
Ambush (Optional - Ambush programmed? qYES qNO) (Your Ambush Code is __ __ )
The Ambush Code (optional) is a 2-digit code that is entered just prior to your Disarm Code. If an intruder forces you to disarm
your system, (a) enter your Ambush Code; (b) enter your Disarm Code; (c) press
Example: If your User Code is 1234 and your Ambush Code is 99, press
T his will send a silent alarm to the central station. The red ARMED light will go out and the window will display "SYSTEM
READY", as if the system were merely disarmed. There will be no indication that an alarm has been sent.
10
Disarming the System
1 Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to
remind you to disarm the system before your Entry Delay time expires.
2 Enter your User Code and press
system has been disarmed.
If you enter an invalid code, the keypad will beep 4 times, signifying an error. Re-enter your
code immediately. 10 seconds before Entry Delay expires, the keypad will emit a pulsing
warning tone.
Alarm Indication/Silencing an Alarm
If the red ARMED light is flashing and "ALARM" is displayed, an alarm occurred while
you were out. Proceed with caution! If you suspect that an intruder may still be on the
premises, leave immediately and call authorities from a neighbor's phone.
To silence an audible alarm:
Enter your code and press J . After the system is disarmed, the window will continue to
display "ALARM" followed by the zone(s) violated. To reset the display, note the zones
violated, then press .
C
J
.
The red ARMED light will go out, indicating that the
J
.
J
9 9 1 2 34 1 2 34
.