Operation (Vc10: Vessel Control System); Starting The Engine - Yanmar 4JH45 Operation Manual

ENGINE OPERATION
OPERATION (VC10: VESSEL
CONTROL SYSTEM)

Starting the Engine

1. Open the seacock (if equipped).
2. Open the fuel tank cock.
3. Turn the battery switch on for engine
and engine control system.
Press the Power switch on the
4.
switch panel of the selected station
(1, ).
Figure 8
The switch panel lamp will come
•
on, and the control head (
"SEL" lamp (
on or flash.
To use the Engine START/STOP
•
switch, be sure to turn the Power
switch ON.
Figure 5
Figure 8
5. If the "Sys on by ID" has been set, enter
the password into the display.
6. Press the control head "SEL" switch.
• Wait until the display shows the engine
data. The display is shown.
60
Figure 9
) will come
Figure 10
2
4
3
1
037627-00X01
7. If the "Start by ID" has been set, enter
the password into the display.
• The "Start by ID" has been set, the
engine can be started in 10 seconds
after entering the password into the
display.
8. Move the remote control handle to the
N (Neutral) position.
Figure 6
)
Figure 7
Control head panel
JH Series Operation Manual
037639-00X00
Figure 9
037638-00X00
Figure 10