Woods Batwing BW240 Operator's Manual page 43

Winch Kit Installation
Figure 41. Roller Assembly Installation
1. Locate and drill one 9/16" hole in each wing using
dimensions shown in Figure 41. Assemble items 1,
2, 3 and 4. Use assembly to locate and drill
remaining holes.
2. Secure idler brackets (1) and rollers (2) to deck
with bolts (5) and nuts (6).
3. Remove cylinder pin: Place channel (10) over
cylinder and cylinder lug. Place wing lock-up
bracket over channel and insert pin (8), washers
(7), and cotter pins (9). NOTE: Washers (7) are
used as spacers and are placed between lock-up
bracket and channel (10) as needed.
MAN0725 (10/3/2008)
1. Front right wing belt shield plate, outer
2. Front wing belt shield plate, inner
3. Front wing belt shield plate, center
4. Bent link, .25 x 1.61 x 23.50
Figure 40. Belt Shielding Installation - Right Wing
5. Rear right wing belt shield plate, inner
6. Link .25 x 1.00 x 27.00
7. Rubber belt, .25 x 8.50 x 27.25
8. Rubber belt, .25 x 8.50 x 43.50
9. Rubber belt, .25 x 8.50x 36.05
10. Rubber belt, .25 x 8.88 x 54.50
11. Rubber belt, .25 x 3.64 x 28.00
12. 1/2 NC x 1-1/2 Carriage bolt GR5
13. 1/2 NC Flange lock nut
14. 3/8 NC x 1 Carriage bolt GR5
15. 3/8 NC Flange lock nut
4. Repeat step to install second channel (10) on
opposite wing.
5. Attach winch assembly to channels (10) using bolts
(5) and lock nuts (6).
6. Move SMV sign and hardware to channel as
shown.
7. Tighten all hardware. See Parts page 71 for
complete diagram and part list.
Figure 42. Winch Channel Installation
Assembly 43