Woods Batwing BW240 Operator's Manual page 12

SAFETY & INSTRUCTIONAL DECALS
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
WARNING
DO NOT EXCEED PTO SPEED OF
1000 RPM
PTO speeds higher than 1000 RPM
can cause equipment failure and
personal injury.
WARNING
O NOT EXCEE PTO SPEE OF
540 RPM
PTO speeds higher than 540 RPM can cause
equipment failure and personal injury.
8 - PN 18864
DANGER
ROTATING DRIVELINE
CONTACT CAN CAUSE DEATH
KEEP AWAY!
DO NOT OPERATE WITHOUT -
All driveline guards, tractor and
equipment shields in place
Drivelines securely attached at both ends
Driveline guards that turn freely on
driveline
11 - PN 19924
12 Safety
Replace Immediately If Damaged!
5 - PN 15922
15922-C
OR
6 - PN 18866
18866-D
18864-C
IG -PRESSURE YDRAULIC OIL LEAKS CAN PENETRATE SKIN
RESULTING IN SERIOUS INJURY, GANGRENE OR DEAT .
Check for leaks with cardboard; never use hand.
Before loosening fittings: lower load, release pressure, and
be sure oil is cool.
Consult physician immediately if skin penetration occurs.
19924-B
7 - PN 15503
DANGER
ROTATING BLADES AND
THROWN OBJECTS
Do not put hands or feet under or into mower when
engine is running.
Before mowing, clear area of objects that may be
thrown by blade.
Keep bystanders away.
Keep guards in place and in good condition.
BLADE CONTACT OR THROWN OBJECTS CAN
CAUSE SERIOUS INJURY OR DEATH.
9 - PN 18865
WARNING
FALLING OFF CAN RESULT IN BEING RUN OVER.
 Tractor must be equipped with ROPS (or ROPS CAB) and seat
belt. Keep foldable ROPS systems in "locked up" position at all
times.
 Buckle Up! Keep seat belt securely fastened.
 Allow no riders.
RAISED EQUIPMENT CAN DROP AND CRUSH.
 Before working underneath, follow all instructions and safety rules in
operator's manual and securely block up all corners of equipment
with jack stands.
 Securely blocking prevents equipment dropping from hydraulic leak-
down, hydraulic system failures or mechanical component failures.
FALLING OFF OR FAILING TO BLOCK SECURELY CAN
RESULT IN SERIOUS INJURY OR DEATH.
WARNING
15503-C
18865--C
MAN0725 (10/3/2008)