Woods Batwing BW240 Operator's Manual page 36

Install 3-Joint Drive (540 RPM Only)
Before installing cutter input driveline to gearbox, check
the tag wired to the driveline and the tag wired to the
input shaft of gearbox. Ensure the tag rpm speeds
match the rpm speed decal on front of cutter. After con-
firming all speeds match, remove and discard tags and
then complete driveline assembly.
1. Attach H-frame (24) to tongue with two cap screw
(44), sleeves (46), cup washers (45), and nut (47).
2. Coat splined end of gearbox input shaft with
grease.
3. Align hole in drive yoke with groove on gearbox
input shaft and slide drive (27) onto shaft.
17. Carrier bearing shield
22. Tongue
24. H-frame
25. Hydraulic hose holder
26. Front half, 3-joint drive
27. Rear half, Telescoping driveshaft
44. 5/8" NC x 2" HHCS GR5
45. 5/8" x 1-3/4" x 14 ga Cup washer
46. 5/8" x 1" x 9/16" Sleeve, HT
47. 5/8" NC Lock nut
48. 1/2" NC x 6-1/2" HHCS GR5
51. 1/2" Flat washer
52. 1/2" x 3.56" Spacer, pipe schedule 40
53. 1/2" NC Flanged lock nut
54. 1/2" NC x 5-1/2 HHCS GR5
55. 3/8" NC x 1" HHCS GR5
56. 3/8" Lock washer
36 Assembly
4. Secure with bolt and nut supplied with drive.
5. Secure driveline carrier bearing to H-frame with
6. Attach front driveline (26) to rear driveline (27) and
7. Attach shield (17) to driveline carrier bearing with
8. Attach spacer (52) and hydraulic hose holder (25)
Figure 29. 3-Joint Drive Installation
cap screw (54), washer (51) and a flanged lock nut
(53).
NOTE: When cutting height is established, adjust
the 3-joint H-frame bearing height so that the front
driveline is parallel to the ground.
tighten clamp bolt and nut.
two cap screws (55) and lock washers (58).
to top hole of H-frame using cap screw (48) and
flanged lock nut (53).
(Rev. 3/13/2009)
MAN0725 (10/3/2008)