Impex IRONGRIP IGS-04 Owner's Manual page 6

Leg curl/extension bench

STEP 2

(See Diagram 2)

A.) Slide a

1 ½" Plastic Spacer (#49) onto the Axle on the Adjustment Plate (#4). Insert

the Axle through the Pivot Barrel on the Main Frame. Slide another Spacer onto the

Axle.

B.) Slide the Weight Holder (#7) onto the Axle and align the holes. Insert a Roll Pin (#12)

through the hole and drive it in with a hammer.

C.) Attach the Leg Developer Frame (#19) onto the Axle on the Adjustment Plate (#4).

Secure it with one M10 x ¾" Allen Bolt (#28) and

D.) Slide the Knee-lock Frame (#13) onto the pivot axle on the Main Frame. Secure it with

one M10 x ¾" Allen Bolt (#28) and

E.) Attach the open bracket on the Handle (#6) to the Seat Support (#2). Secure it with two

M10 x 2 ¾" Carriage Bolts (#46),

1 3/8" Washer (#27).

¾" Washers (31), and M10 Aircraft Nuts (#35).

DIAGRAM 2

Table of Contents