Step 3. Mount Thermostat Wallplate - Honeywell 36 Owner's Manual

STEP 3. MOUNT THERMOSTAT WALLPLATE

Position wallplate on wall. Level the
wallplate for appearance if desired. Use a
pencil to mark the two mounting holes that
best fit the application.
Remove wallplate from wall, and drill
3/16 inch holes in wall (if drywall) as
marked. For firmer material such as
plaster or wood, drill 7/32 inch holes.
Gently tap anchors (provided) into drilled
holes until flush with the wall.
Reposition wallplate over holes, pulling
wires through wiring opening. Loosely
insert two mounting screws into holes.
Level for appearance only; thermostat
functions properly even when not level.
Tighten mounting screws.
WIRES
THROUGH WALL
WALL
ANCHORS
(2)
8
WALL
MOUNTING
HOLES
MOUNTING
SCREWS
M15044
69-0939—1