Honeywell 36 Owner's Manual page 23

(The setpoint temperature range is 40 to 90°F
(7 to 31°C) for heating and 45 to 99°F (9 to
37°C) for cooling.) Press
your other system temperature setpoint.
NOTE: The program times are the same for
both heating and cooling.
Press or
temperature setpoint is displayed. Press
, or
Daytime
Evening
above steps for programming the rest of the
day. The first day is now programmed.
IMPORTANT
Repeat all the above steps for each
day of the week that has a different
program than your first day. Refer
to Copying a Day section to copy
any program day to another.
Heat/Cool
to switch to
Settings
until the other desired
and repeat the
Night
Run
Press when all the days are
Program
programmed.
Copying a Day
NOTE: Your thermostat must be in the
program mode to use the copy
feature.
Press then
Morning
to be copied if different from the day
displayed. Press
the day to be copied to is displayed. Press
.
Copy
NOTE: "donE" will be displayed for two
seconds and then the normal
program display will be shown.
Repeat the above steps for all the desired
days then press
23
to select the day
Day
then
Copy
Day
Run
.
Program
69-0939—1
until