Delta Car Kit; Antenna; Phone Holder Hdh-40; Microphone - Benefon DELTA TDP-40-TN2 Service Manual

3.2 DELTA CAR KIT

The Car Kit includes a phone holder (HDH-40), a car box (CIU-40), an antenna, an
installation base, a hf speaker, a microphone and a cable. The Car Kit sales package
also includes an installation material bag, which contains the necessary installation
equipment. On the 6th page you will find a diagram of connections explaining how to
install the Car Kit.
Caution:
The Car Kit should be installed by Benefon authorized installer only. An end user
should never attemp to install the Car Kit alone without any professional assistance.
The professional installers have the required tools and knowledge to install the Car
Kit properly and safely. Also the terms of warranty demand that the Car Kit is
installed by professional personnel. Cable routing may cause interference with the
components of the vehicle's electronic systems (such as inginition and braking sys-
tems). It is recommended that cable is not routed next to these electronic compo-
nents.

3.2.1 Antenna

Choose a suitable place for the antenna. It is recommended that you place the
antenna on the roof of the vehicle.

3.2.2 Phone Holder HDH-40

Choose such a place for the phone holder in the vehicle that will be both easy and
safe when using the phone. First, fix the installation base to the place you have cho-
sen, and then install the phone holder in the installation base.

3.2.3 Microphone

Install the microphone so that it is aimed directly at the user, and comes as close as
possible to the user's mouth. A good place for the microphone is near the rearview
mirror where the noise level is lower than, for example, beside a windshield pillar. It
is also possible to install the microphone on a sun visor, but then it will be inconve-
nient to use the sun visor and microphone at the same time. One alternative would
be a swan-neck microphone as it can be placed closest to the user's mouth.

3.2.4 Cable

Obtain the necessary +-electricity from a suitable place, preferably directly from the
battery of the vehicle. Connect the fuse chamber to the +-wire. You will find the fuse
chamber in the installation material bag. Connect the ground lead to the frame of the
car with a short wire.
TDP-40E6_fm5.fm
Product: TDP-40-TN2 (Delta) /
28.1.1999
Installation Instructions
4