Table of Contents
Advertisement
3.2 CAR KIT
The Car Kit includes a hf holder, a car box, an installation base, a hf speaker, a
microphone, a button unit, a power cable and a system cable. The Car Kit
sales package also includes an installations material bag, which contains the
necessary installation equipment. On the third page you will find a diagram of
connections explaining how to install the Car Kit.
Caution:
The Car Kit should only be installed by a Benefon authorized installer. The end
user should never attempt to install the Car Kit without professional assistance.
Professional installers have the required tools and knowledge for installing the
Car Kit properly and safely. The terms of warranty also require that the Car Kit
is installed by professionally trained personnel. Cable routing may cause
interference with the components of the vehicle's electronic systems (such as
ignition and braking systems). It is recommended that cables not be routed
next to such electronic components. Make sure that the hf holder, button unit,
microphone and speaker do not obstruct the air bag system.
3.2.1 Power Cable
The Car Kit should be installed only in vehicles with 12 Volts, negative on
chassis system. When connecting the power cable make sure that it is not
connected to the car box.
Obtain the necessary (+)-electrical current from a suitable place, preferably
directly from the battery of the vehicle. Connect the fuse chamber to the (+)-
wire. You will find the fuse chamber in the installation materials bag. Connect
the ground lead to the frame of the car with a short wire.
3.2.2 Hf Holder KGS75
Choose such a place for the hf holder in the vehicle that will be both easy and
safe when using the phone. First, fix the installation base to the place you have
chosen, and then install the hf holder in the installation base.
3.2.3 Microphone
The microphone should be located 20-50 cm from the driver's mouth, and at
least 90 cm from the loudspeaker. Make sure that the "eyes" are directed
towards the driver. Mount the microphone using the supplied adhesive tape.
A good place for the microphone is near the rearview mirror where the noise
level is lower than, for example, beside a windshield pillar. It is also possible to
install the microphone on a sun visor, but then it will be inconvenient to use the
sun visor and microphone at the same time.
6DP_80GB.fm
Product: TDP80DN /
11.10.2001
Installation Instructions
8
Advertisement
Table of Contents
