Table of Contents
Advertisement
H
IMPORTANT! Use only a Power Wheels
battery with a Power Wheels
of any other battery or fuse will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
ating your vehicle for the first time. Charge the battery for
at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow
these instructions may damage your battery and will void
your warranty.
1
Bumper Cover
(Battery Clamp)
• Loosen the screw in the rear bumper cover (battery
clamp), as shown
• Remove the rear bumper cover (battery clamp).
2
• Place a Power Wheels
®
battery compartment, as shown.
Battery Installation
®
Type H 6 volt
®
25 Amp fuse installed. Use
®
6 volt charger before oper-
6 volt battery upright in the
3
Battery Connector
• Plug the battery connector into the motor harness
connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again. Do not force
the battery connector into the motor harness connector.
4
• Replace the rear bumper cover (battery clamp).
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten
15
Motor Harness
Connector
Advertisement
Table of Contents
