Reversing The Door - CDA FF880 Manual For Installation, Use And Maintenance

Reversing the door

We recommend you seek the help of another individual to support
the doors whilst performing this operation.
1. Carefully remove the two hinge cover plates and two cover caps
from the control panel.
2. Remove the control panel, ensuring that the wires are not damaged.
We recommend you support the control panel with masking tape
on the top of the freezer whilst it is detached.
3. Remove the screws securing the upper hinge whilst supporting the
door. Lift the upper hinge and door away and place the door safely
to prevent damage.
4. Remove the upper hinge from the door.
5. Remove the third hinge plate securing screw and relocate on the
opposite side, leaving the screwhead approximately 3mm proud of
the appliance.
Left cover plate
Cover cap
upper hinge securing screws
upper hinge
fig. 3
Right cover plate
control panel
fig. 4
9