Wet Suction; Emptying The Tank - Makita VC4710 Operating Instructions Manual

6.2.2 Wet suction

6.2.3 Emptying the tank after
wet suction
After emptying the tank: clean the
rim of the tank and the seals in the
intermediate ring and the upper sec-
tion of vacuum before refitting them.
If the seal or groove is dirty or dam-
aged, the suction performance will
be reduced.
Before reinserting the suction hose:
clean the inlet fitting and hose col-
lar.
Original Instruction
0
auto
A A
A A
Makita VC4710
1. Be sure that the vacuum is
switched off and unplugged.
2. Open the retaining clamps (A)
and remove the upper sec-
tion of the vacuum cleaner.
3. The material collected must
be disposed of in accor-
dance with the applicable
regulations.
4. Attach the upper section of
the vacuum.
5. Close the retaining clamps
(A). Ensure that the retaining
clamps fit properly.
19