illy X7 Metodo Iperespresso Instruction Manual page 17

5
Press the coffee switch to start the decalcification cycle the coffee switch
The machine automatically starts performing washing cycles at set intervals
At the end of the automatic decalcification cycle, lasting approx. a half hour, the machine emits an beep
and the coffee switch starts flashing again
Remove and empty the tank; wash it and fill it with 1 lt of fresh water (up to the MAX level) ; empty
the container and place it under the delivery unit
Press the coffee switch to start the rinsing cycle; the coffee switch
The machine starts delivering water at set intervals lasting a few minutes
At the end of the rinsing cycle the triangular icon stops flashing and the machine emits beep
Empty the container
The machine is ready to be used
WARNING:
- Should a power outage occur while performing the decalcification procedure, it will be necessary to
repeat the procedure from the start
- If the declacification procedures are not performed, calcium may cause malfunctioning not covered by the warranty
- It is advisable to use our decalcification agent
- Do not use vinegar, lye, salt, formic acid because they may damage the machine
6
6
8
turns off
B
7
max
1litro
1litre
turns off 5
7
9
10
1litro
1litre
EN
8
9
10
43