Electrolux EVE916BA User Manual page 41

INSTALLATION OF THE EFE956BA & EFE916BA
Cabinet construction for slot in installation
600mm minimum
vertical clearance from
combustible surfaces
600mm
895mm
To convert the freestanding appliance to a slot in
installation the kick panel provided on the appliance
is removed and the appliance is mounted on a plinth.
This enables a continuous cupboard kickboard to
be installed, giving a more integrated appearance.
There is no clearance requirement between oven and
adjacent side cabinets.
Installation of anti-tilt brackets and stops
• T he brackets are to be secured to the back wall with
appropriate fasteners.
• T he bottom edge of the brackets rest on the horizontal
support surface.
• T wo stops are to be screwed to the plinth in locations
as shown (stops provided). The stops locate into slots
in the base of the appliance to prevent the product
from being pulled forward when installed.
• M easurements from the rear wall are to be adjusted if
there are tiles etc, that come between the appliance
and the wall.
183
414
475
Location of holes for front stops
900mm
600mm
minimum
Anti-tilt
brackets
Gas Hob 765mm
Induction Hob 761mm
This surface to be level with the
top edge of the kick board
• O nce services are connected, product can be lifted
onto the plinth and pushed back carefully, ensuring the
appliance engages into both brackets at the rear and
the front stops.
• I f the product requires removal for service, it must be
lifted at the front approximately 5mm to clear the front
stops prior to being pulled forward.
41
755mm
900mm