Installation Of The Appliance - Electrolux EVE916BA User Manual

38

INSTALLATION OF THE APPLIANCE

Installing splashback (models with hob only)
Fit splashback to rear of hob with three screws provided.
Cabinet requirements
models EFE956BA & EFE916BA are designed to fit into a
900mm wide gap between standard kitchen cabinets. The
appliance integrates with the kitchen cabinets by matching
the height, depth and kick panel. The cooker may also
be installed at the end of a line of benches or with a free
space either side. In addition, a slot-in type installation is
catered for allowing a continuous cabinetry kick panel to
be used. model EVE916BA is designed to be built into
cabinetry either below a benchtop or into a vertical cabinet.
WArnInG!
• T he cooker must be installed and serviced only by an
authorised person.
• A Certificate of Compliance MUST be supplied to be
kept by the customer.
• T he packing materials must be removed before you
install the cooker.
• T he surrounding kitchen cabinets must be able
to withstand 85°C. Electrolux WILL NOT accept
responsibility for damage caused by installation into
kitchen cabinets which cannot withstand 85°C.
• T he pipes used for installation MUST have sufficient
loops so the cooker can be moved for service
(gas model).
• T he vents, openings and air spaces MUST NOT
be blocked.
• T he anti-tilt brackets and chain or front stops MUST be
installed to avoid accidental tipping (freestanding and
slot-in models).
• Y ou MUST NOT lift or pull the cooker by the
door handle.
• The cooker MUST be checked every five years.
Gas model clearance requirements
• E nsure the appliance is installed in accordance
with clauses 6.2.5 and 6.10.1.1 of AS/NZS 5601.1
or clauses 6.9.1 and 6.9.5 of AS/NZS 5601.2 with
regard to clearances to combustible surfaces and
materials, and clearances to rangehoods and exhaust
fan. To ensure clearances of 200mm from burners to
vertical combustible surfaces observe the minimum
dimension of 100mm from each side of the cooker to
combustible surfaces.
• C learances to combustible surfaces may be reduced
if combustible surfaces are protected in accordance
with clause 6.10.1.2 of AS/NZS 5601.1, or clause 6.9.2
of AS/NZS 5601.2.
• W hen setting the cooker height, ensure the top of
the cooker is at least 10mm higher than the level
of the benchtop.