Gas Hob Troubleshooting - Electrolux EVE916BA User Manual

32

GAS HOB TROUBLESHOOTING

If there is a problem with the appliance, please:
• C heck the points listed below before calling for service.
It may be possible to avoid a call by fixing the problem
yourself – and so continue cooking.
problem
Burner will not light even though
the sparker is working.
No spark is obtained when
control knob is activated.
Flames uneven or tending to lift. Flame ports blocked or wet.
Flames not staying on when
knob released.
Low heat, slow cooking.
Flame safeguard
The gas hob is fitted with a safety system that will stop
the flow of gas if for any reason the flame goes out during
operation. If this happens, the burner can be restarted, but
will require the knob to remain depressed
for approximately 5 seconds.
WArnInG!
• K eep hands clear of burners when lighting.
• If burner does not ignite within 5 seconds, turn knob to
'Off' position, allow gas to disperse, then try lighting again.
• B urners MUST be operated between 'HIGH' and
'LOW' settings only.
EnVIrOnmEnT!
To conserve gas, place the pan centrally over the burner
and adjust the flame so that it does not go past the edge
of the cookware.
NOTE: In the absence of electrical power, carry out
the ignition directly to the burner with a hand held
ignition source.
possible cause
Knob not held down long enough in 'High'
position for flame safeguard to engage.
Gas supply valve turned off.
Wrong knob turned off.
Port blockage in ignition area.
Ignition spark plugs wet or dirty.
Electricity supply is disconnected or
switched off.
Ignition spark plugs wet or dirty.
Burner incorrectly fitted.
Knob not held down long enough in 'High'
position for flame safeguard to engage.
Knob not set between 'High' and 'Low'.
Dirt or spillage on flame safeguard sensor.
Incorrect cooking burner selection for the
size of pot being used.
remedy
Repeat lighting procedure and hold knob
down for 5 seconds in 'High' position.
Turn on gas supply to appliance.
Ensure the knob you are turning corresponds
to the burner you want to light.
Ensure the ports in the ignition area are clean
and dry.
Dry or clean ignition spark plugs.
Switch on electricity or check fuses.
Dry or clean ignition spark plugs.
Clean or dry flame ports.
Ensure this component is fitted correctly.
Repeat lighting procedure and hold knob
down for 5 seconds in 'High' position.
Knob mUST be set between these positions.
Clean flameguard sensor tip.
Refer to page 31 for correct burner selection.
Further information
When you need information, service or replacement parts
or have a warranty enquiry, please contact the Customer
Care Centre:
• A ustralia - 1300 363 640, 8.00am-5.00pm
EST monday to Friday
• N ew Zealand - 09 573 2384, 8.00am-5.00pm EST
monday to Friday
Please have the following information ready: model,
model Number & Serial Number. This is shown on the
data plate which is visible when the oven door is open.